Page 1 of 1

Logs for IPsec

Posted: 26 Jun 2020, 14:46
by mch
Hello

Where is the logs for IPsec? I want to look at previuos attempts on setting up tunnels, IKE, Phase1 and 2.

Best Regards
Christer

Re: Logs for IPsec

Posted: 29 Jun 2020, 07:36
by Peter
Hello.

Information about IPsec tunnel establishment can be found in primary two places.

1. Normal logs
1.1 Such as in the WebUI memory logs or if you have setup a log receiver for Syslog (e.g. InCenter) or our own log format using InControl.
2. The "ike -snoop <ip>" CLI command.

Logs from #2 is recommended as it shows a greater level of detail about what is happening.

The following How-To may also be of interest when troubleshooting IPsec related problems:

viewtopic.php?f=8&t=3699

Best regards
/Peter